Linksys PCM200 V3 instructions for kernel 2.4?
"Jason A. Pfeil" <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
Hello, list! I can't seem to find any instructions that are valid for the
Linksys PCM200 V3 card. I can provide you with any information that you
may need to help diagnose the problem.
I saw in the list archives that on 8/2, Mr. Becker reported that the card
works with the latest tulip.c driver and the latest tulip-diag.c program.
I get output from the tulip-diag.c program but when I try to compile the
tulip.c driver, I get two undefined symbols:
register_driver
unregister_driver
Anyone know what module will provide these symbols for the kernel?
Many thanks!
--Jason
I am running Stock RH7.3 with the stock 2.4.18-3 kernel compiled non-SMP
for the i686 processor.
--
Jason A. Pfeil 13700 Richmond Park Dr. N. #1104
Jacksonville, FL 32224
[email protected]
_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip