Re: Unresolved symbols w. 2.4.7
Donald Becker <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On Fri, 16 Aug 2002 [email protected] wrote: > I'm trying to get my Conexant NIC to work on a Compaq Presario 17xl365 > laptop. Other users of the same laptop have reported success in getting > the card to work with the tulip driver. I'm using Red Hat 7.2 with > 2.4.7. Both pci-scan.c and tulip.c compiles, but when doing "insmod" I > get a lot of messages about "unresolved symbol". Try downloading and compiling the driver with mkdir /tmp/netdrivers/ cd /tmp/netdrivers/ ncftp ftp://ftp.scyld.com/pub/network/netdrivers.tgz tar xfvz netdrivers.tgz make make install I'm temporarily recommending this approach instead of the binary or source RPM. Red Hat has several different kernels that are distributed as being "7.2", and each requires different module versions. -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Second Generation Beowulf Clusters Annapolis MD 21403 410-990-9993 _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip