Recompiled kernel & Tulip problems
[email protected] (Jesse F. Hughes)
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
Hey ho. I'm at a loss here. After recompiling my kernel to add USB support, my machine fails to load my PCMCIA network card properly. tulip-diag reports that an "ADMtek AL985 Centaur (OEM CardBus)" was found at 0, and was never assigned a valid IRQ. A glance at /var/log/messages shows that, when the card successfully loads, it is called ADMtek Centaur-C (Linksys) rev 17, not ADMtek AL985 Centaur. But, I notice that the entry for the card that tulip-diag reports is the same as the entry for the card in tulip.c that I see in /var/log/messages. Namely, 0xab08 0x13d1. I've recompiled the modules, but still, I get errors when I plug the card in. The errors in the messages log are pretty generic -- init_module: Device or resource busy, bind 'tulip' to socket 0 failed: Operation not permitted. Now, the card still works with my old kernel just fine. So, it's possible that I've misconfigured my new kernel, but I don't know what to look for. I would be happy to provide more details, if someone could tell me what's relevant. I'm using a 2.2.18 kernel. pci-scan, cb_shim and tulip modules are all new downloads, cb_enabler has not been recompiled since I don't know where I got the source for it to begin with. -- Jesse Hughes "Radicals are interesting because they were considered 'radical' by the people who played with them who wrote a lot of math work that modern mathematics depends on." --Another JSH history lesson _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip