Re: Recompiled kernel & Tulip problems
Donald Becker <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On Tue, 1 Oct 2002, Jesse F. Hughes wrote: > After recompiling my kernel to add USB support, That immediately hints at an IRQ mapping problem. > my machine fails to > load my PCMCIA network card properly. tulip-diag reports that an > "ADMtek AL985 Centaur (OEM CardBus)" was found at 0, and was never > assigned a valid IRQ. > > A glance at /var/log/messages shows that, when the card successfully > loads, it is called ADMtek Centaur-C (Linksys) rev 17, not ADMtek > AL985 Centaur. But, I notice that the entry for the card that > tulip-diag reports is the same as the entry for the card in tulip.c > that I see in /var/log/messages. Namely, 0xab08 0x13d1. The messages refer to the same chip. The driver has access to more specific information such as the PCI subsystem ID registers. > I've recompiled the modules, but still, I get errors when I plug the > card in. The errors in the messages log are pretty generic -- > init_module: Device or resource busy, bind 'tulip' to socket 0 failed: > Operation not permitted. What is the exact messages, including those from the PCMCIA subsystem? -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Second Generation Beowulf Clusters Annapolis MD 21403 410-990-9993 _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip