problems with cabletype detection
morbidmind <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Organization | malleus dei |
| Message-ID | <[email protected]> |
Hi folks,
i have a adaptec ana6911a/tx, i modprobe tulip, ifconfig eth0 up does
well, but pinging anyone doesnt give any response. i am not able to
give detailed logs, sorry. my network adapter is connected via a
twisted-pair cable to a 10/100Mbit-switch. the cable is a little bit
scratched. under win nt 4 my adapter works well with 10MBit
full-duplex with full speed, but with 100MBit full & half-duplex i get
only minimal throughput. only about 10 byte / sec...
my tcp/ip configuration is a little bit diffrent:
ip 192.168.66.206
netmask: 255.255.255.224
gateway: 192.168.66.193
dns: 192.168.66.129
xxx.xxx.xxx.xxx
any help would be very great
best regards,
Hendrik Lücke-Tieke
--
Mit freundlichen Grüssen
morbidmind mailto:[email protected]
_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip