Re: problems with cabletype detection
Donald Becker <[email protected]>
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On Sat, 5 Oct 2002, morbidmind wrote: > i have a adaptec ana6911a/tx, i modprobe tulip, ifconfig eth0 up does > well, but pinging anyone doesnt give any response. i am not able to > give detailed logs, sorry. We must know the driver version number and detection message. > my network adapter is connected via a > twisted-pair cable to a 10/100Mbit-switch. the cable is a little bit > scratched. under win nt 4 my adapter works well with 10MBit > full-duplex with full speed, but with 100MBit full & half-duplex i get > only minimal throughput. only about 10 byte / sec... You should get a better cable before attempting further debugging. -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Second Generation Beowulf Clusters Annapolis MD 21403 410-990-9993 _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip