During boot time after "bring interface eth0 up" the tulip card light off.
"Charley Lee" <[email protected]> Thu, 19 Dec 2002 16:02:27 -0800
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
I have Tulip 21040 ethernet card. During installation the card was detected. But it doesn't work. I noticed that each time the eth0 interface is brought up the act light on the card turned off. Can someone tell me what's wrong? I installed Red Hat 6.0. The kernel is 2.2.5-15. Thanks, Charley Lee [email protected] _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip