Re: During boot time after "bring interface eth0 up" the tulip card light off.
Donald Becker <[email protected]> Fri, 20 Dec 2002 10:52:52 -0500 (EST)
| Newsgroups | gmane.linux.drivers.tulip.general |
|---|---|
| Message-ID | <[email protected]> |
On Thu, 19 Dec 2002, Charley Lee wrote: > I have Tulip 21040 ethernet card. During installation the card was detected. > But it doesn't work. I noticed that each time the eth0 interface is brought > up the act light on the card turned off. What driver version? What is the detection message? What does 'tulip-diag -a -ee' report? -- Donald Becker [email protected] Scyld Computing Corporation http://www.scyld.com 410 Severn Ave. Suite 210 Scyld Beowulf cluster system Annapolis MD 21403 410-990-9993 _______________________________________________ tulip mailing list, [email protected] To change to digest mode or unsubscribe visit http://www.scyld.com/mailman/listinfo/tulip