Re: Tulip and PowerPC endian issue?

> Has anyone with a PPC tried to the driver with a message level of 15?

There are additional messages when I try to ping something on the card's
subnet with a debug level of 15:

Nov 30 18:01:19 eth0 kernel: tulip.c:v0.95f 11/17/2002  Written by
Donald Becker <[email protected]> 
Nov 30 18:01:19 eth0 kernel:   http://www.scyld.com/network/tulip.html 
Nov 30 18:01:19 eth0 kernel: eth1: ADMtek Centaur-C rev 17 at
0xc902f000, 00:10:7A:69:F0:79, IRQ 30. 
Nov 30 18:01:19 eth0 kernel: eth1:  MII transceiver #1 config 1100
status 7849 advertising 05e1. 
Nov 30 18:11:08 eth0 kernel: eth1: MII link partner 0000, negotiated
0000. 
Nov 30 18:11:08 eth0 kernel: eth1: No link beat on the MII interface,
status 7849. 
Nov 30 18:11:11 eth0 kernel: eth1: MII link partner 0000, negotiated
0000. 
Nov 30 18:11:11 eth0 kernel: eth1: No link beat on the MII interface,
status 7849. 
Nov 30 18:12:11 eth0 kernel: eth1: MII link partner 45e1, negotiated
05e1. 
Nov 30 18:12:11 eth0 kernel: eth1: Setting full-duplex based on MII #1
link partner capability of 45e1. 

-- 
Jim Rowe
Advanced CounterMeasure Systems
Email: [email protected]

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip