tulip driver for BeOS.

Hi, I installeed BeOS the other day and my NIC doesn't work in it. It's 
a Linksys LNE100TX rev 4.1 card.  The BeOS tulip drivers support up to 
version 3 of this card.  Using tulip-diag I discovered that the chip on 
the card is an ADMtek AL985 Centaur-P.  So I was thinking about wading 
in and possibly writing a driver for the card so that it will work in 
BeOS. I was wondering if someone could point me in the right direction 
for resources on this card.  Linksys doesn't have much and ADMtek 
doesn't seem to have any info on this chip either.  Thank you very much.

Jeremy

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip