Re: Netgear FA511 on RedHat 7.3

On 16 May 2003, Jared Warren wrote:

> > Enable all messages in the driver
> >   mii-diag eth1 --msg-level 0xfffffff
..
> > Re-connect the cable to see if you get an interrupt message from the
> > link change indication.
...
> 1.  Reboot (note that my inittab is set to default runlevel 3, so XWin
> doesn't load).
> 
> 2.  mii-diag eth1 --msg-level 0xffffffff (that's 8 f's)
> 
> I got the normal output (as seen earlier in this thread) from that.

You should get a bunch of messages, especially when you bring the
interface up.

> 7.  Plug in ethernet cable.
> 
> I didn't see anything displayed to the console (of course, the machine
> didn't lock up either).

Bring the interface up, and look for the last message before freezing.

-- 
Donald Becker				[email protected]
Scyld Computing Corporation		http://www.scyld.com
914 Bay Ridge Road, Suite 220		Scyld Beowulf cluster system
Annapolis MD 21403			410-990-9993

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip