Re: Re :IRQ unknown for Accton EN-1216 (ADMtek Comet) [Resend as Plain Text]

I have 2 different tulip workalikes, an embedded SiS 900 and a Network 
Everywhere/Linksys ADMTek board.

Stock RH 8.0 installation, kernel 2.4.18-14.

I had the exact same errors, namely:

PCI: No IRQ known for interrupt pin A of device 00:09.0.
eth0: ADMtek Comet rev 17....., IRQ 0.

Or something very similar.

Well, my workaround was simple but a bit drastic.  I set my BIOS's 
"Plug-n-Play O/S" setting to "off".  Thereafter, everything worked fine, 
with IRQ's being assigned properly, and the stock tulip.o being used 
just fine.


-- 
**********

This message is directed in confidence solely to the
person(s) identified.  This message may also be subject to
privilege and all rights to that privilege are expressly
claimed.  If you have received this message in error, please
notify the sender(s) and destroy the message immediately.

**********

Kevin Wong, LL.B.
E-Mail:  [email protected]



_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip