*** Link Jabber ***

Hi,

i've serius problems geting tulip to work, my card currently works with the 
old de4x5.c driver. Last Tulip driver i've tryed was the one in 2.6.2-r1 
network card is a Adaptec ANA-6922. MII-Diag gives the following

Using the default interface 'eth0'.
Basic registers of MII PHY #1:  0000 ffff 0000 ffff 0000 ffff 0000 ffff.
 The autonegotiated capability is 0000.
No common media type was autonegotiated!
This is extremely unusual and typically indicates a configuration error.
Perhaps the advertised capability set was intentionally limited.
 Basic mode control register 0x0000: Auto-negotiation disabled, with
 Speed fixed at 10 mbps, half-duplex.
 Basic mode status register 0xffff ... ffff.
   Link status: established.
 Remote fault detected!
   *** Link Jabber! ***
 Your link partner advertised ffff: Flow-control 100baseT4 100baseTx-FD 
100baseTx 10baseT-FD 10baseT, w/ 802.3X flow control.
   End of basic transceiver information.

ifconfig:

eth0      Link encap:Ethernet  HWaddr 00:00:D1:1F:32:83
          inet addr:192.168.0.12  Bcast:192.168.0.255  Mask:255.255.255.0
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:34 dropped:0 overruns:0 carrier:34
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:9 Base address:0xac00

de4x5 driver:

eth0: DC21143 at 0xc000 (PCI bus 0, device 12), h/w address 00:00:d1:1f:32:83,
      and requires IRQ9 (provided by PCI BIOS).
de4x5.c:V0.546 2001/02/22 [email protected]

is this a driver problem or is my card some kind of damaged. Is there any 
other debuging output i can provide?

Jens

_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip