Tulip for Micronet cards

Chava Livyatan <[email protected]> Thu, 18 Mar 2004 15:20:54 +0200

Newsgroups	gmane.linux.drivers.tulip.general
Message-ID	<D843913E5B7F3B40B74DCE1BFDB0012240F014@Mars>

Hello,

	We are using Micronet cards with 21143-PD chip.  In the last 6 or 8
months Micronet has changed its 
	phy chip on the card. It used  to have kendin , then National VS29AC
and now it is National VS27AB.

	In addition the rom chip has changed from philips to TI.

	We are running redHad 7.2 and experiencing the following problem:

	When the machine is booted sometime the link led is on , sometimes
it is off.
	The same is inspected at the switch that the card is connected to 

	Our questions are:
	-	Is anybody aware to these changes Micronet has done?
	-	Does anyone know if any additional/different initialization
is needed for the new 
		Micronet card (with phy VS27AB)?
	-	Is there any new tulip driver that solves this problem.

	We appreciate any  response.

Chava Leviatan

Flash Networks Ltd.
[email protected]
http: www.flash-networks.com

 
_______________________________________________
tulip mailing list, [email protected]
To change to digest mode or unsubscribe visit
http://www.scyld.com/mailman/listinfo/tulip