Trouble initializing 3C900 (vortex) adapter

Wondering if I should expect trouble with Fedora Core initializing my
3C900 TPO adapter.  System is running fine with Windows 2000, but I'd
like to get moved over to Linux.  All installed fine.  During boot, the
adapter appears to install successfully (i.e. the 3c59x module), but it
never receives an IP address (via DHCP).

I don't have the specific errors with me (didn't take time to write them
down last night), but those being reported were not the common ones
discussed on the http://www.scyld.com/networking/vortex page.

Mostly just wondering if I should expect to make adjustments to an
out-of-the-box (or would that be just-off-the-web) install of Fedora, or
if I have deeper troubleshooting to do.

Thanks,
Mitch


_______________________________________________
vortex mailing list
[email protected]
http://www.scyld.com/mailman/listinfo/vortex