Re: problems w/3c59x on 3CCFE575BT
dean gaudet <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <[email protected]> |
On Sun, 22 Dec 2002, Donald Becker wrote: > On Sun, 22 Dec 2002, dean gaudet wrote: > > > i had to re-enable cardbus support in the kernel and futz with a few > > other things, but here's what i get after "modprobe 3c59x": > > > > pci-scan.c:v1.11 8/31/2002 Donald Becker <[email protected]> http://www.scyld.com/linux/drivers.html > > 3c59x.c:v0.99Xf 11/17/2002 Donald Becker, [email protected] > > http://www.scyld.com/network/vortex.html > > eth0: 3Com 3CCFE575BT Cyclone CardBus at 0x4800, 00:50:04:b4:e7:29, IRQ 11 > > eth0: CardBus functions mapped 10c00080->ca838080. > > 8K buffer 5:3 Rx:Tx split, autoselect/10baseT interface. > > MII transceiver found at address 0, status 282d. > > Using bus-master transmits and whole-frame receives. > > OK, that looks fine. What does 'mii-diag' report about the link? # mii-diag -V mii-diag.c:v2.02 5/21/2001 Donald Becker ([email protected]) http://www.scyld.com/diag/index.html Using the default interface 'eth0'. Basic registers of MII PHY #0: 3000 282d 0300 e54b 0001 45e1 0001 0000. The autonegotiated capability is 0000. No common media type was autonegotiated! This is extremely unusual and typically indicates a configuration error. Perhaps the advertised capability set was intentionally limited. Basic mode control register 0x3000: Auto-negotiation enabled. You have link beat, and everything is working OK. Your link partner advertised 45e1: Flow-control 100baseTx-FD 100baseTx 10baseT-FD 10baseT, w/ 802.3X flow control. End of basic transceiver informaion. -dean _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex