Re: problems w/3c59x on 3CCFE575BT
dean gaudet <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <[email protected]> |
On Sun, 22 Dec 2002, Donald Becker wrote: > On Sun, 22 Dec 2002, dean gaudet wrote: > > > i had to re-enable cardbus support in the kernel and futz with a few > > other things, but here's what i get after "modprobe 3c59x": > > > > pci-scan.c:v1.11 8/31/2002 Donald Becker <[email protected]> http://www.scyld.com/linux/drivers.html > > 3c59x.c:v0.99Xf 11/17/2002 Donald Becker, [email protected] > > http://www.scyld.com/network/vortex.html > > eth0: 3Com 3CCFE575BT Cyclone CardBus at 0x4800, 00:50:04:b4:e7:29, IRQ 11 > > eth0: CardBus functions mapped 10c00080->ca838080. > > 8K buffer 5:3 Rx:Tx split, autoselect/10baseT interface. > > MII transceiver found at address 0, status 282d. > > Using bus-master transmits and whole-frame receives. > > OK, that looks fine. What does 'mii-diag' report about the link? woah -- this is bizarre. the box is a router, and it seems to route packets a lot faster than it handles local TCP sessions. using a host on wlan0 to wget a file from a host on eth0 i can achieve >600kbyte/s. but when i run wget on the router itself the rate is only 20kbyte/s. -dean _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex