RE: 3c905C-TX : not working in 100Mbps / Full Duplex ?

Emmanuel Viennet <[email protected]>
Newsgroups gmane.linux.drivers.vortex.devel
Message-ID <[email protected]> 
I upgraded to RedHat 8.0, which use 3c59x version LK1.1.18-ac
and now all is working perfectly
(but take care of checking EEPROM config of all new cards,
as some are preconfigured in 100 instead of NWAY autonegociation).


I suppose the old driver (LK1.1.16), shipped
with RedHat 7.3, does not fully support the
3c905C-TX/TX-M [Tornado] (rev 78)


Thank you very much for your support.

Emmanuel
-- 
Emmanuel Viennet
LIPN - Institut Galilee - Universite Paris-Nord       



_______________________________________________
vortex mailing list
[email protected]
http://www.scyld.com/mailman/listinfo/vortex
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.