Re: cannot activate eth0 (3c59x [duh]) in RH8.0 dual boot system
Bogdan Costescu <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <Pine.LNX.4.44.0302031312110.27729-100000@kenzo.iwr.uni-heidelberg.de> |
On Sun, 2 Feb 2003, Jordan Weber-Flink wrote: > (note, this is the complete output, eth0 is not listed) Then you have a networking configuration problem, that doesn't involve the driver. > 3c59x: Donald Becker and others. www.scyld.com/network/vortex.html > 00:0c.0: 3Com PCI 3c905B Cyclone 100baseTx at 0xd800. Vers LK1.1.18-ac > ***INVALID CHECKSUM 0011*** This indicates a problem with the EEPROM that keeps the settings on the card. Did you use any kind of tool to modify the media type ? > /etc/sysconfig/netw../ifcfg-eth0: > DEVICE=eth1 Well, if ifcfg-eth0 points to eth1, I won't look further :-) > /etc/modules.conf entry: > alias eth0 3c59x This is correct. -- Bogdan Costescu IWR - Interdisziplinaeres Zentrum fuer Wissenschaftliches Rechnen Universitaet Heidelberg, INF 368, D-69120 Heidelberg, GERMANY Telephone: +49 6221 54 8869, Telefax: +49 6221 54 8868 E-mail: [email protected] _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex