Re: cannot activate eth0 (3c59x [duh]) in RH8.0 dual boot system
Ruben van der Leij <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <[email protected]> |
On Mon, 2003-02-03 at 04:24, Jordan Weber-Flink wrote: > Please, advise me. I need to get this network running. > 3c59x: Donald Becker and others. www.scyld.com/network/vortex.html > 00:0c.0: 3Com PCI 3c905B Cyclone 100baseTx at 0xd800. Vers LK1.1.18-ac > ***INVALID CHECKSUM 0011*** <7>divert: atex Please download the following file: ftp://ftp.3com.com/pub/nic/3c90x/3c90x2.exe Unpack to a floppy-disk (it's an self-extracting archive). Boot from a DOS-system disk. Swap and start the DOS config and diagnostic program. 3C90XCFG.EXE. Restore all defaults (plug&play, auto-negotiation) and save those to EEPROM. That should both your inability to negotiate a common linkspeed and -duplex and fix your 'INVALID CHECKSUM'-error. -- Ruben van der Leij <[email protected]> _______________________________________________ vortex mailing list [email protected] http://www.scyld.com/mailman/listinfo/vortex