Re: 3c900 combo problem
Donald Becker <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Message-ID | <[email protected]> |
On Wed, 14 May 2003, aserwew wrote:
> Hi, I have this net card. I use linux kernel 2.4.20. I have problem:
>
> 3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
> See Documentation/networking/vortex.txt
> 00:0e.0: 3Com PCI 3c900 Boomerang 10Mbps Combo at 0xe000. Vers LK1.1.16
> 00:10:4b:95:47:52, IRQ 11
> product code 4d50 rev 00.0 date 04-15-98
> Internal config register is 302d8, transceivers 0xe138.
> 8K word-wide RAM 3:5 Rx:Tx split, 10baseT interface.
> 00:0e.0: Media override to transceiver type 3 (10base2).
It's been a long time since we have had 10base2 questions!
Please confirm that
You intended to use the 10base2 transceiver
You have a BNC 'T' connector attached directly to the NIC card, not
a cable
The cable is marked as 50ohm
Each end of the cable has a 50 ohm terminator
> eth0: Trying to send a packet, Tx index 0.
> eth0: Media selection timer tick happened, 10base2.
> dev->watchdog_timeo=500
--
Donald Becker [email protected]
Scyld Computing Corporation http://www.scyld.com
914 Bay Ridge Road, Suite 220 Scyld Beowulf cluster system
Annapolis MD 21403 410-990-9993
_______________________________________________
vortex mailing list
[email protected]
http://www.scyld.com/mailman/listinfo/vortex