Rx errors with Cyclone
"Pfunk Mallone" <[email protected]>
| Newsgroups | gmane.linux.drivers.vortex.devel |
|---|---|
| Organization | Lycos Mail (http://www.mail.eudoramail.com) |
| Message-ID | <[email protected]> |
Hello,
I'm receiving huge numbers of errors from my eth1 network card. I've been searching through the archives, but problems that seem similar, end up slightly different.
At first, I was thinking a IRC conflict, but I dont' see any evidence of that...
I've downloaded and played with most of the scyld diag tools, but I'm not sure which ones are relevant.
Here's some data (more available):
Redhat 7.2 (Source kernel 2.4.20)
------------------- related dmesg ----------------
PCI: Found IRQ 12 for device 00:0a.0
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
00:0a.0: 3Com PCI 3c905B Cyclone 100baseTx at 0xdc00. Vers LK1.1.16
PCI: Found IRQ 9 for device 00:0b.0
00:0b.0: 3Com PCI 3c905B Cyclone 100baseTx at 0xe000. Vers LK1.1.16
PCI: Found IRQ 11 for device 00:0c.0
PCI: Sharing IRQ 11 with 00:08.0
00:0c.0: 3Com PCI 3c905B Cyclone 100baseTx at 0xe400. Vers LK1.1.16
---------------------------------------------------
-------------------- related lspci ----------------
00:0a.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone] (rev 64)
Subsystem: 3Com Corporation 3C905B Fast Etherlink XL 10/100
Flags: bus master, medium devsel, latency 64, IRQ 12
I/O ports at dc00 [size=128]
Memory at e6001000 (32-bit, non-prefetchable) [size=128]
Expansion ROM at e3000000 [disabled] [size=128K]
Capabilities: [dc] Power Management version 1
00:0b.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone] (rev 64)
Subsystem: 3Com Corporation 3C905B Fast Etherlink XL 10/100
Flags: bus master, medium devsel, latency 64, IRQ 9
I/O ports at e000 [size=128]
Memory at e6000000 (32-bit, non-prefetchable) [size=128]
Expansion ROM at e4000000 [disabled] [size=128K]
Capabilities: [dc] Power Management version 1
00:0c.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone] (rev 64)
Subsystem: 3Com Corporation 3C905B Fast Etherlink XL 10/100
Flags: bus master, medium devsel, latency 64, IRQ 11
I/O ports at e400 [size=128]
Memory at e6002000 (32-bit, non-prefetchable) [size=128]
Expansion ROM at e5000000 [disabled] [size=128K]
Capabilities: [dc] Power Management version 1
---------------------------------------------------
-------------------- /proc/interrupts -------------
0: 20115296 XT-PIC timer
1: 2 XT-PIC keyboard
2: 0 XT-PIC cascade
4: 12 XT-PIC serial
8: 1 XT-PIC rtc
9: 953090 XT-PIC eth1
10: 20 XT-PIC aic7xxx
11: 20937 XT-PIC eth2
12: 6413656 XT-PIC eth0
14: 425819 XT-PIC ide0
15: 257 XT-PIC ide1
----------------------------------------------------
-------------------- pci-config --------------------
pci-config.c:v2.03 4/15/2002 Donald Becker ([email protected])
http://www.scyld.com/diag/index.html
Device #1 at bus 0 device/function 0/0, 71008086.
Device #2 at bus 0 device/function 7/0, 71108086.
Device #3 at bus 0 device/function 7/1, 71118086.
Device #4 at bus 0 device/function 7/2, 71128086.
Device #5 at bus 0 device/function 7/3, 71138086.
Device #6 at bus 0 device/function 8/0, 3208100c.
Device #7 at bus 0 device/function 9/0, 71789004.
Device #8 at bus 0 device/function 10/0, 905510b7.
Device #9 at bus 0 device/function 11/0, 905510b7.
Device #10 at bus 0 device/function 12/0, 905510b7.
Need a new email address that people can remember
Check out the new EudoraMail at
http://www.eudoramail.com
_______________________________________________
vortex mailing list
[email protected]
http://www.scyld.com/mailman/listinfo/vortex