RE: fLASHING PROBLEM

> the image on the access point to flash it, it gives me nothing but junk on
> the terminal. There cud be a possibility that I am not jumping it correctly

Probably your minicom settings are wrong? You
want 4800, 8 data, 1 stop, no parity, no hardware handshake.

The jumping thing did not seem that critical to me. I have read on this
list you have to remove the jumper while the lights are still blinking.
You will know you got it by the terminal output.

Once you have it booting from SRAM you will be able to watch it go
through the whole process. It takes a few minutes (like 5 or 10).
When it gets to the end it tries to reboot itself. You will see that.

On both of my boxes it stuck at that point and I powered off, pulled
the SRAM card, powered on and they came up in Linux.

Brian