RE: fLASHING PROBLEM

Hi=20

I short the jumper j2 and powered it on. The two lights 4&5 are not
blinking, How much time I have to wait for them to start blinking. They =
are
lit up but not blinking and j2 is still short. Also please tell me am I
supposed to get anything useful from the starting or do I have to wait =
for
some 5-10 min. after I release the j2, they blink once only and then =
goes
off.=20

Please suggest, I am confused on the timing of the whole process from =
the
starting.

Gaurav

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Brian =
Wilson
Sent: Thursday, February 19, 2004 12:45 PM
To: Linux Access Point Development
Subject: RE: [LinuxAP-dev] fLASHING PROBLEM

> the image on the access point to flash it, it gives me nothing but =
junk on
> the terminal. There cud be a possibility that I am not jumping it
correctly

Probably your minicom settings are wrong? You
want 4800, 8 data, 1 stop, no parity, no hardware handshake.

The jumping thing did not seem that critical to me. I have read on this
list you have to remove the jumper while the lights are still blinking.
You will know you got it by the terminal output.

Once you have it booting from SRAM you will be able to watch it go
through the whole process. It takes a few minutes (like 5 or 10).
When it gets to the end it tries to reboot itself. You will see that.

On both of my boxes it stuck at that point and I powered off, pulled
the SRAM card, powered on and they came up in Linux.

Brian



_______________________________________________
LinuxAP-dev mailing list
[email protected]
http://linuxAP.ksmith.com/mailman/listinfo/linuxap-dev