Re: fLASHING PROBLEM

Hi

Did you compared your board picture with the ones at bh.udev.org
or opensource.instant802.com site? I'm still wondering if your
2455 is our 2450...

the J2 is a reset, turn the unit on with terminal attached
(4800 8N1 if using linuxap) and short it quickly. in no more
than 1-2 secs ALIOS should print it's messages on terminal

THEN wait to see what linux is doing. here it didn't take
10 minutes to reflash ... but trust on the terminal output,
not in our rough timings!!

if the ALIOS boot messages doesn't shows up, you don't sucess
resseting J2 and you'll have to start over again

OTOH, are you sure your terminal and RS232C cable are ok?
(just to avoid more hasless!)

Cheers
!3runo


Gaurav Dawra wrote:
> Hi 
> 
> I short the jumper j2 and powered it on. The two lights 4&5 are not
> blinking, How much time I have to wait for them to start blinking. They are
> lit up but not blinking and j2 is still short. Also please tell me am I
> supposed to get anything useful from the starting or do I have to wait for
> some 5-10 min. after I release the j2, they blink once only and then goes
> off. 
> 
> Please suggest, I am confused on the timing of the whole process from the
> starting.
> 
> Gaurav