Re: Re: write_sock stream errors

On Thu, 2004-12-16 at 16:39, Peter T. Breuer wrote:
> > slave1 enbd-server: enbd-server: server (0) set default signal handlers
> > for slave server 548  
> > slave1 enbd-server: enbd-server: server (0) set default signal handlers
> > for slave server 551  
> > 
> > The client does not get any errors (at least under the IO load I'm
> > subjecting it). Here's nbdinfo:
> 
> Well, maybe the protocol of having the server write the hello first is
> a bit silly :-).
> 
> > It's not necessarily a show-stopper, as there are no errors generated on
> > the client, but could it be? And what do they mean?
> 
> Could it be that the server is faster than the client?

No. Both machines are exactly the same spec. Also, I noticed that it is
happening *always* (looked at the past logs and it's always there),
exactly 1 minute and 55 seconds after establishing the initial
connection between server and client, and under no I/O (well, excluding
that one block with the partition table). Ah well, I will give 2.4.32 a
go.

Nikos




This email has been independently scanned for viruses and any virus detected has been removed using McAfee anti-virus software