boot problems with latest 2004.3 release

Hello,

I recently acquired an old Miata 500au machine and have been
unsuccessfully trying to get Gentoo to boot off of the disk for a few
days and thought I would break down and ask if anyone has any ideas
about how to get around the problems I am experiencing.

I am able to boot from the livecd and go through the installation
without a problem, I emerge vanilla-sources and aboot.

When I reboot, the kernel starts to load and then I get the following
messages.  The machine never fully boots, it just prints these messages
over and over until I power down the machine and restart.


CY82C693 IDE controller
hda: DMA interrupt recovery
hda: lost interrupt
hda: dma_timer_expiry: dma status == 0x24
.
.
.


Has anyone experienced this or have any suggestions on how to fix it?

Thanks,
Russ

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.6 (FreeBSD)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org

iD8DBQFB4/IgHEbmlWWNudARAooeAJ9guEzzmQgpsf5mn5zXHEUr8aKtVwCggjK/
taoPv7tUtvelOfVfu68i144=
=vW3j
-----END PGP SIGNATURE-----