Re: boot problems with latest 2004.3 release

Russell Francis <[email protected]>
Newsgroups gmane.linux.gentoo.alpha
Message-ID <[email protected]>
Hello again,

I think I have discovered why this was occuring and will list what I
have found for two reasons,

1) Googling the "hda: lost interrupt" message indicates that at least a
few other people have/had this issue and this post may be helpful to them.

2) See what others think, I suspect it is an issue with the Linux kernel
, perhaps someone more knowledeable than I can confirm or deny this
suspicion.

After a bit of experimentation I was able to get kernel-2.4.28 to
compile and boot successfully.  After that, I was able to change 1 option

General setup --->
	(Generic) Alpha system type

to

General setup --->
	(Miata) Alpha system type

and generate another kernel that displays the "lost interrupt" messages
and never finishes booting.  Below is a diff between the working .config
file and the broken .config file.

Any input or suggestions are welcome.  Should I follow up with the
kernel developers?

Thanks in advance,
Russ


--- working-config-3	2005-01-15 04:58:27.000000000 -0500
+++ broken-config	2005-01-15 05:07:10.000000000 -0500
@@ -1,5 +1,5 @@
  #
-# Automatically generated make config: don't edit
+# Automatically generated by make menuconfig: don't edit
  #
  CONFIG_ALPHA=y
  # CONFIG_UID16 is not set
@@ -21,7 +21,7 @@
  #
  # General setup
  #
-CONFIG_ALPHA_GENERIC=y
+# CONFIG_ALPHA_GENERIC is not set
  # CONFIG_ALPHA_ALCOR is not set
  # CONFIG_ALPHA_XL is not set
  # CONFIG_ALPHA_BOOK1 is not set
@@ -37,7 +37,7 @@
  # CONFIG_ALPHA_LX164 is not set
  # CONFIG_ALPHA_LYNX is not set
  # CONFIG_ALPHA_MARVEL is not set
-# CONFIG_ALPHA_MIATA is not set
+CONFIG_ALPHA_MIATA=y
  # CONFIG_ALPHA_MIKASA is not set
  # CONFIG_ALPHA_NAUTILUS is not set
  # CONFIG_ALPHA_NONAME is not set
@@ -58,10 +58,12 @@
  # CONFIG_SBUS is not set
  # CONFIG_MCA is not set
  CONFIG_PCI=y
+CONFIG_ALPHA_EV5=y
+CONFIG_ALPHA_EV56=y
+CONFIG_ALPHA_CIA=y
+CONFIG_ALPHA_PYXIS=y
+# CONFIG_ALPHA_SRM is not set
  CONFIG_VERBOSE_MCHECK=y
-CONFIG_ALPHA_BROKEN_IRQ_MASK=y
-# CONFIG_SMP is not set
-CONFIG_EARLY_PRINTK=y
  # CONFIG_DISCONTIGMEM is not set
  # CONFIG_ALPHA_LARGE_VMALLOC is not set
  CONFIG_PCI_NAMES=y




Brian Parkhurst wrote:
>
> Is there a way to specify nodma on the aboot prompt?
>
> I've had this time of issue on older Intel systems where I needed to
> include nodma on the parameters being passwd to the booting kernel.

I tried this and it changed the following lines on bootup from this

     ide0: BM-DMA at 0x9080-0x9087, BIOS settings: hda:DMA, hdb:pio
     ide1: BM-DMA at 0x9088-0x908f, BIOS settings: hdc:pio, hdd:pio

to this

     ide0: BM-DMA at 0x9080-0x9087, BIOS settings: hda:pio, hdb:pio
     ide1: BM-DMA at 0x9088-0x908f, BIOS settings: hdc:pio, hdd:pio

with no other noticable difference.  The system still stalled out during
boot with the "lost interrupt" messages.

> -----Original Message-----
> From: Russell Francis [mailto:[email protected]]
> Sent: Tuesday, January 11, 2005 7:35 AM
> To: [email protected]
> Subject: [gentoo-alpha] boot problems with latest 2004.3 release
>
> Hello,
>
> I recently acquired an old Miata 500au machine and have been
> unsuccessfully trying to get Gentoo to boot off of the disk for a few
> days and thought I would break down and ask if anyone has any ideas
> about how to get around the problems I am experiencing.
>
> I am able to boot from the livecd and go through the installation
> without a problem, I emerge vanilla-sources and aboot.
>
> When I reboot, the kernel starts to load and then I get the following
> messages.  The machine never fully boots, it just prints these
> messages
> over and over until I power down the machine and restart.
>
>
> CY82C693 IDE controller
> hda: DMA interrupt recovery
> hda: lost interrupt
> hda: dma_timer_expiry: dma status == 0x24
> .
> .
> .
>
>
> Has anyone experienced this or have any suggestions on how to fix it?
>
> Thanks,
> Russ
>
signature.asc (application/pgp-signature, 254 B)
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.6 (FreeBSD)
Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org

iD8DBQFB6PJXHEbmlWWNudARAnNAAJ0Rbm4r7PeQR6xuO9iJJKZY7ahtuwCeP40e
ObQnKak4vYUAmDpxTqhbhD8=
=NeDt
-----END PGP SIGNATURE-----
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.