Re: compile errors && Matrox

you wont have to ctrl+c it cause it should be near the very end ;)
check out these bugs to see what it *might* look like
6748 6745 6627
-mike

----- Original Message -----
From: "Bob Lockie" <[email protected]>
To: <[email protected]>
Sent: Monday, August 19, 2002 22:51
Subject: Re: [gentoo-newbies] compile errors && Matrox


>
> >these error msgs are almost always useless.  the real meat of the
> >problem is above that ... usually you see something like 'parse error'
> >or 'signal 11 caught' or some other compile error
>
> Is there a log somewhere?
> I don't want to watch it and ctrl-c when I see the problem.
>
>
> I found the actuall stuff XFree says:
>
> (II) Loading sub module "mga_hal"
> (II) LoadModule: "mga_hal"
> (WW) Warning, couldn't open module mga_hal
> (II) UnloadModule: "mga_hal"
> (EE) MGA: Failed to load module "mga_hal" (module does not exist, 0)
> (II) MGA(0): Matrox HAL module not loaded - using builtin mode setup
instead
> (--) MGA(0): Chipset: "mgag200"
> (==) MGA(0): Using AGP 1x mode
>
> (EE) MGA(0): Static buffer allocation failed, not initializing the DRI
>
> (EE) MGA(0): Need at least 9216 kB video memory at this resolution, bit
depth
>
>
>
> _______________________________________________
> gentoo-newbies mailing list
> [email protected]
> http://lists.gentoo.org/mailman/listinfo/gentoo-newbies
>