Re: compile errors && Matrox

On Mon, Aug 19, 2002 at 11:19:58PM -0400, mike wrote:
> you wont have to ctrl+c it cause it should be near the very end ;)
> check out these bugs to see what it *might* look like
> 6748 6745 6627
> -mike

and did you already compile/insert the matrox dri module from the kernel? 

> 
> ----- Original Message -----
> From: "Bob Lockie" <[email protected]>
> To: <[email protected]>
> Sent: Monday, August 19, 2002 22:51
> Subject: Re: [gentoo-newbies] compile errors && Matrox
> 
> 
> >
> > >these error msgs are almost always useless.  the real meat of the
> > >problem is above that ... usually you see something like 'parse error'
> > >or 'signal 11 caught' or some other compile error
> >
> > Is there a log somewhere?
> > I don't want to watch it and ctrl-c when I see the problem.
> >
> >
> > I found the actuall stuff XFree says:
> >
> > (II) Loading sub module "mga_hal"
> > (II) LoadModule: "mga_hal"
> > (WW) Warning, couldn't open module mga_hal
> > (II) UnloadModule: "mga_hal"
> > (EE) MGA: Failed to load module "mga_hal" (module does not exist, 0)
> > (II) MGA(0): Matrox HAL module not loaded - using builtin mode setup
> instead
> > (--) MGA(0): Chipset: "mgag200"
> > (==) MGA(0): Using AGP 1x mode
> >
> > (EE) MGA(0): Static buffer allocation failed, not initializing the DRI
> >
> > (EE) MGA(0): Need at least 9216 kB video memory at this resolution, bit
> depth
> >
> >
> >
> > _______________________________________________
> > gentoo-newbies mailing list
> > [email protected]
> > http://lists.gentoo.org/mailman/listinfo/gentoo-newbies
> >
> 
> _______________________________________________
> gentoo-newbies mailing list
> [email protected]
> http://lists.gentoo.org/mailman/listinfo/gentoo-newbies