Re: compile errors && Matrox

>> you wont have to ctrl+c it cause it should be near the very end ;)
>> check out these bugs to see what it *might* look like
>> 6748 6745 6627
>> -mike
>
>and did you already compile/insert the matrox dri module from the kernel? 

I think it is compiled into the kernel but I wonder why it is failing to initialize a buffer.
I get a graphic display.
I just don't like warnings.

>> 
>> ----- Original Message -----
>> From: "Bob Lockie" <[email protected]>
>> To: <[email protected]>
>> Sent: Monday, August 19, 2002 22:51
>> Subject: Re: [gentoo-newbies] compile errors && Matrox
>> 
>> 
>> >
>> > >these error msgs are almost always useless.  the real meat of the
>> > >problem is above that ... usually you see something like 'parse error'
>> > >or 'signal 11 caught' or some other compile error
>> >
>> > Is there a log somewhere?
>> > I don't want to watch it and ctrl-c when I see the problem.
>> >
>> >
>> > I found the actuall stuff XFree says:
>> >
>> > (II) Loading sub module "mga_hal"
>> > (II) LoadModule: "mga_hal"
>> > (WW) Warning, couldn't open module mga_hal
>> > (II) UnloadModule: "mga_hal"
>> > (EE) MGA: Failed to load module "mga_hal" (module does not exist, 0)
>> > (II) MGA(0): Matrox HAL module not loaded - using builtin mode setup
>> instead
>> > (--) MGA(0): Chipset: "mgag200"
>> > (==) MGA(0): Using AGP 1x mode
>> >
>> > (EE) MGA(0): Static buffer allocation failed, not initializing the DRI
>> >
>> > (EE) MGA(0): Need at least 9216 kB video memory at this resolution, bit
>> depth