Re: PCMCIA Network card issue

[email protected]
Newsgroups gmane.linux.gentoo.newbies
Message-ID <[email protected]>
On Wed, Sep 11, 2002 at 10:38:25PM -0500, William Stenross wrote:
> I have tried looking at the pcmcia/network.opts and /pcmcia/network 
> files to no success.  
> 
> Here's the actually error message being written to the logs.
> 
> [cardmgr] starting, version is 3.2.0
> [cardmgr] socket 1: CardBus hotplug device
> [dhcpcd] dhcpStart: ioctl SIOCGIFHWADDR: No such device
> [rc-scripts] Failed to bring eth0 up

yeah, i think this is like what you suggest by yourself, the device is
not recognised and the driver not loaded. Are you sure that you compiled
the correct driver for your network card?

the cardctl uses afaik the same way as lspci to display the card
information. 
another hint, i solved a problem like that on a slackware system by
upgrading the cardmgr software..

greetz
stijn

> 
> when i attempt to start dhcpcd after I log in, it gives the same error 
> message.
> 
> I did cardctl and got the following message.
> 
> #  cardctl config
> 
> Socket 1:
> Vcc 3.3V Vpp1 3.3V Vpp2 3.3V
> interface type is "cardbus"
> irq 11 [exclusive] [level]
> function 0:
> 
> # cardctl ident
> 
> Socket 1:
> product info: "3Com Corporation", "3CCFE575CT", "Lan Cardbus CArd", "004"
> manfid: 0x0101, 0x5257
> function: 6 (network)
> 
> So if I might guess, cardmgr appears to recognize my device.  However, 
> when i use "ifconfig", the PCMCIA card does not show up.  Where might my 
> problem lie?  Is it with an improper DHCP configuration?  Or is the 
> PCMCIA card not being properly loaded?
> 
> -Bill
> 
> 
> 
> 
> 
> Joseph Santaniello wrote:
> 
> >Idependant of sorting out the kernel issue with mounting /boot have a
> >look at:
> >/etc/pcmcia/network.opts and /etc/pcmcia/network. Specify in there that
> >you want to use dhcp.
> >
> >Joseph
> >
> >
> >On Sun, 2002-09-08 at 22:10, William Stenross wrote:
> > 
> >
> >>I currently am trying to get Gentoo working on a Dell Inspiron 3700 
> >>laptop with a 3com 3ccfe575ct PCMCIA network card.  However, the nework 
> >>card fails to start when I start the computer.  When I had redhat 
> >>installed on this laptop, it was using kernel driver 3c575_cb for the 
> >>PCMCIA card.  
> >>
> >>Here is the exact error message during start-up:
> >>
> >>"failed to bring eth0 up"
> >>
> >>This happens when it is trying to start dhcpcd.  It does however, load 
> >>PCMCIA support during the start-up.
> >>
> >>When I configured the kernel during the install it only had options for 
> >>3c574 and 3c589.  Would those work with my PCMCIA card?
> >>
> >>I tried to recompile the kernel with support for those two drivers, but 
> >>I'm not sure if I'm recompiling the kernel correctly.
> >>
> >>Here are the steps I go through:
> >>
> >>cd /usr/src/linux
> >># make menuconfig
> >><check to make sure 3c374 and 3c389 are marked to be included>
> >># make dep && make clean bzImage modules modules_install
> >># mv /boot/bzImage /boot/bzImage.orig 
> >><here it gives me the error message that bzImage doesn't exist.  
> >>Shouldn't it exist though, since I have already compiled a kernel before 
> >>(when I was installing gentoo)?>
> >># cp /usr/src/linux/arch/i386/boot/bzImage /boot
> >>
> >>When I reboot, it doesn't seem to load the new kernel. (I could be wrong).
> >>
> >>I have some experience with linux and unix systems, but this is the 
> >>first time I've really taken a look under the hood, so to speak, so any 
> >>help or direction towards places on the web that might help me would be 
> >>greatly appreciated.  If any additional information is needed feel free 
> >>to ask.
> >>
> >>thanks.
> >>
> >>-Bill
> >>
> >>
> >>
> >>
> >>_______________________________________________
> >>gentoo-newbies mailing list
> >>[email protected]
> >>http://lists.gentoo.org/mailman/listinfo/gentoo-newbies
> >>   
> >>
> >
> >
> >_______________________________________________
> >gentoo-newbies mailing list
> >[email protected]
> >http://lists.gentoo.org/mailman/listinfo/gentoo-newbies
> >
> >
> > 
> >
> 
> 
> 
> 
> _______________________________________________
> gentoo-newbies mailing list
> [email protected]
> http://lists.gentoo.org/mailman/listinfo/gentoo-newbies
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.