Re: ...boot problems...

Michael Teter <[email protected]>
Newsgroups gmane.linux.gentoo.newbies
Message-ID <[email protected]>
I fixed the network problem.  I was confused, and
thought I had an on-board Intel NIC, but I actually
have a PCI 3Com (It's a Dell, never looked before :)

You pegged the XSESSION thing.  I had made a typo
while following install instructions, and I had my
XSESSION set to "XSESSION kde...", with no = between
them.  My mistake.

All is well now, thanks very much for your reply.

Michael

--- Quinn Harris <[email protected]> wrote:
> I don't know the exact cause of the XSESSION errors,
> but you might check
> '/etc/rc.conf'.  If there is a line that isn't
> commented with '#' that
> contains XSESSION=[something] I would comment it
> out.  This raises the
> question, are you booting into X?
> 
> I expect the network problem is completely
> unrelated.
> I would first ensure that you are using the proper
> driver for your
> network card and that the driver is detecting your
> card.  If everything
> is good the driver should emit some text probably
> stating the MAC
> address or something.  You can check your kernel
> logs for this text,
> posibly in /var/log/kernel/current.  Or use
> Shift+PageUp to scroll up on
> the primary console.
> 
> Do you think you selected the right network card
> when you configured
> your kernel?  If you don't know exactly what card to
> select, you can
> take a look at /proc/pci.  If the card is
> functioning it should show up
> there (assuming its a PCI card).
> 
> 
> On Wed, 2002-09-11 at 13:23, Michael Teter wrote:
> > Howdy.
> > 
> > I just installed Gentoo on my Dell development
> > machine.
> > 
> > I followed the x86 guide from the Gentoo site.
> > 
> > A first note, I don't know what the hell I'm
> doing.  I
> > just want to make that clear :)
> > 
> > On boot I get some errors.
> > 
> > I see:
> > ==================================================
> > ( some messages ) 
> > 
> > * Activating swap...
> > Adding Swap: blah blah [ok]
> > /sbin/runscript.sh: XSESSION: command not found
> > /sbin/runscript.sh: XSESSION: command not found
> > /sbin/runscript.sh: XSESSION: command not found
> > /sbin/runscript.sh: XSESSION: command not found
> > /sbin/runscript.sh: XSESSION: command not found
> > * Remounting root filesystem read-only (if
> necessary)
> > [ok]
> > * Checking root filesystem...
> > fsck 1.27 (8-Mar-2002)
> > fsck: fsck.xfs: not found
> > fsck: Error 2 while executing fsck.xfs for
> /dev/hda3
> > [ok]
> > * Remounting root filesystem read/write... [ok]
> > * Checking all filesystems...
> > fsck 1.27 (8-Mar-2002)
> > /dev/hda1: clean, 26/26104 files, 8750/104391
> blocks
> > [ok]
> > 
> > ( a few more messages )
> > 
> > /sbin/runscript.sh: XSESSION: command not found
> > * Setting hostname to mtdev02... [ok]
> > 
> > ( more messages, with an occasional XSESSION error
> as
> > listed above )
> > 
> > * Loading module sg...
> > * Failed to load sg [!!]
> > 
> > * Loading module sr_mod...
> > * Failed to load sr_mod [!!]
> > 
> > ( more XSESSION errors )
> > 
> > * Bringing lo up... [ok]
> > 
> > ( several more XSESSION errors )
> > 
> > ( some success lines, more XSESSION errors )
> > 
> > * Bringing eth0 up...
> > * Failed to bring eth0 up [!!]
> > 
> > ( a couple more success lines, followed by a final
> > XSESSION error )
> > 
> >
> ====================================================
> > 
> > I attempted to follow the install guide
> completely.  I
> > did stage1, 2, and 3.
> > 
> > The part that I suspect most was my kernel
> > configuration.  I added pre-emptable kernel and
> things
> > suggested in the doc.
> > 
> > I'm particularly confused by the XFS-related
> errors,
> > since I specifically turned XFS off in the kernel,
> and
> > I'm only using ext3 (for /boot) and ReiserFS (for
> /).
> > 
> > Any suggestions?  If I'm in really sad shape, tell
> me
> > "go back to RedHat" if that's what I should do.
> > 
> > Thanks,
> > Michael
> > 
> > 
> > __________________________________________________
> > Yahoo! - We Remember
> > 9-11: A tribute to the more than 3,000 lives lost
> > http://dir.remember.yahoo.com/tribute
> > _______________________________________________
> > gentoo-newbies mailing list
> > [email protected]
> >
>
http://lists.gentoo.org/mailman/listinfo/gentoo-newbies
> > 
> 
> 
> _______________________________________________
> gentoo-newbies mailing list
> [email protected]
>
http://lists.gentoo.org/mailman/listinfo/gentoo-newbies


__________________________________________________
Do you Yahoo!?
Yahoo! News - Today's headlines
http://news.yahoo.com
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.