Re: GRUB install issue w/1.4_rc1

Is there a LILO install doc so I know what to put in /etc/lilo.conf?

----- Original Message -----
From: "Mark A Basil" <[email protected]>
To: <[email protected]>
Sent: Wednesday, December 01, 1999 1:18 AM
Subject: Re: [gentoo-newbies] GRUB install issue w/1.4_rc1


> I was having the same problems as you are describing.  Although, I'm using
an onboard scsi controller, and an addon IDE ATA100 controller.  Lilo seems
to work just fine.  Try that out just to get your system booted ( I know
your anxious ;o), then work on Grub if you want.  Boot off of the cd, mount
and chroot to your installation, emerge lilo (not installed by default),
edit lilo.conf, run lilo, enjoy your new Gentoo system.
>
> -mb