Re: GRUB install issue w/1.4_rc1

Check the Linux Doc Project at http://www.tldp.org
You should be able to find not only the Lilo docs, but any other doc you
might need there.
----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Tuesday, October 01, 2002 2:14 PM
Subject: Re: [gentoo-newbies] GRUB install issue w/1.4_rc1


> Is there a LILO install doc so I know what to put in /etc/lilo.conf?
>
> ----- Original Message -----
> From: "Mark A Basil" <[email protected]>
> To: <[email protected]>
> Sent: Wednesday, December 01, 1999 1:18 AM
> Subject: Re: [gentoo-newbies] GRUB install issue w/1.4_rc1
>
>
> > I was having the same problems as you are describing.  Although, I'm
using
> an onboard scsi controller, and an addon IDE ATA100 controller.  Lilo
seems
> to work just fine.  Try that out just to get your system booted ( I know
> your anxious ;o), then work on Grub if you want.  Boot off of the cd,
mount
> and chroot to your installation, emerge lilo (not installed by default),
> edit lilo.conf, run lilo, enjoy your new Gentoo system.
> >
> > -mb
>
> _______________________________________________
> gentoo-newbies mailing list
> [email protected]
> http://lists.gentoo.org/mailman/listinfo/gentoo-newbies