Re: Re: Gentoo Linux Desktop Configuration Guide...Can't Start X

Hmmm.... Do a whereis or which on startx...then type the full path. If that works make sure you have this path in your .bashrc.  
Also if you do an emerge -s xfree does it say it's installed.  Verify you have a XF86config/-4 as well.
On Fri, Oct 04, 2002 at 02:45:39AM -0400, Wilson Brown wrote:
> Hello All,
> 
> Need Help.
> 
> Completed the "Gentoo Linux 1.4 Installation Instructions" and everything
> seem to check out OK.
> Started working my way through the "Gentoo Linux Desktop Configuration
> Guide......not OK.
> 
> use="cups" emerge kde
> 
> 30 hours after I pressed Enter, I got my cursor back (and they say I'm not a
> patient person).
> 
> Have several nice naps!
> 
> After running xf86config(a few times) when I enter:
> 
> startx
> 
> I get:
> 
> bash: startx: command not found
> 
> What do I do now?
> 
> Thanks for any help,
> 
> wb
> The Ancient Welkiner
> 
> 
> _______________________________________________
> gentoo-newbies mailing list
> [email protected]
> http://lists.gentoo.org/mailman/listinfo/gentoo-newbies
>

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.7 (GNU/Linux)

iD8DBQE9nT6wsxJEZAn9OsoRArO1AJ9DhGoUZ3T1gYfNHeMHM+WrDmiNGwCfQubx
3vWZ0XOiRIWmrAxM9FHGaI8=
=halP
-----END PGP SIGNATURE-----