Re: partitioning
Wolf J.Flywheel <[email protected]> Sat, 19 Oct 2002 23:50:15 -0400
| Newsgroups | gmane.linux.gentoo.newbies |
|---|---|
| Organization | Department of Redundancy Department |
| Message-ID | <[email protected]> |
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
On Saturday 19 October 2002 22:43, Glenn Murphy wrote:
> on to the swap partition (do the same), then the root partition (and do
> the same again). (and would this be at the beginning of the drive or
> end? Or does it matter?) But, will I need to specify that the swap
I don't think it matters unless you decide you need to remove a
partition and make it bigger. In that case, it's only possible to
"resize" the partition(s) adjacent to the free space. I usually just
build out from the beginning.
Note: If you're planning to install an entire system from source, you
may want to make the root filesystem ("/") five to ten times larger than
the installation guide recommends. I made mine 2GB and now I keep
running out of space; if I'd made it 20GB I'd have been safe for a while
longer. I'd never manage to compile something like Mozilla or Wine now,
with only 70MB left! I'm going to have to make /usr a new partition to
get more space.
> partition be type 82 (and would the boot partition as well as the root
> partition be type 83?). If so, that will be done outside of cfdisk,
> right? I didn't find a way in cfdisk to specify the type. If I do
Actually I thought I saw a "Type" option in cfdisk, but maybe it was
only available *after* a partition was created. It doesn't much matter;
the type will be set when you do mke2fs, mkswap, mkwhatever. Type 83 is
used for ext2, ext3, reiserfs, maybe others; it's sort of a container
type.
> need to specify, how would I? Would I want Logical or Primary for
You only need to make a primary partition if you plan to use the drive
with DOS or Windows; Linux doesn't care. You may only have one primary
(or is it two?) but any number of logical ones. IIRC, DOS will only boot
from a primary partition... but it's been years since I've had that on
any of my drives, so I doubt that I *do* remember correctly!
So, if you're going to *boot* one of the partitions *into* Windows,
it'll need to be a primary. Non-boot partitions may be logical
partitions, and Linux boot loaders (grub, LILO, etc.) will boot any of
them (within BIOS limitations, of course).
Good luck,
- --
// Carl Hudkins :: ICQ 5723399 :: PGP 50238D9E
//
// "I do not take a single newspaper, nor read one a month;
// and I feel myself infinitely the happier for it."
// --Thomas Jefferson
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: For info see http://www.gnupg.org
iD8DBQE9sif8lLp/6lAjjZ4RAra/AJ9V8C6vCtCxRY2yf1ePL/AXvSzZLgCdEczd
o1rO1Bzxdfm6AUyJkIZ6wXM=
=oG2K
-----END PGP SIGNATURE-----