Re: problems with PowerBook G4

Hello, I'm Sik and I want to ask you some questions:

I have a PbG4 867MHz 12" (with a nvidia) and I can't have running the
airport and MOL.
Your TI-Book have a radeon or a nvidia? Because I only can take 8bits of
color with MOL and I can see any thing.

The second one is about the airport, it's the old one 11Mbps?

> hello,
> I have installed Gentoo PPC (2005.1) on my 800 Mhz Titanium PowerBook
> G4 successfully (it boots). I have some problems, however, and I was
> wondering if anyone could help me. As it stands, I can not do the
> following which I would like:
> 1) I cannot configure ethernet (on eth0) or airport (on eth1, wifi1,
> and wlan1). after running "alias eth0=sungem" and "alias eth1=airport",
> "alias wifi1=airport", and "alias wlan1=airport", I still cannot
> connect using net.eth0 and net.eth1, etc, config and ifup eth0/ifup
> eth1. It says (I am booted into OSX now because I cannot get mail from
> Gentoo, so this might be a little off):
> ifconfig: eth0: device not found
> or something like that. The same goes for eth1. Is there a guide
> somewhere that I could read about configuring ethernet and airport
> under gentoo?

> 4) This is a question about Mac-On-Linux. I was wondering how to
> install and run it. I have it installed, but when I run what it says to
> on the man pages, I get some errors about the display, and I think the
> OSX partition (I am really sorry I am so vague, but I forgot it since
> running MOL is not as high a priority right now as getting my linux
> system configured). It does the same thing when run in an xterm or
> Terminal Window (GNOME).

-- 
[email protected] mailing list