Re: Configure NI GPIB-USB-HS based on serial number

Hi Ron,
Syntactically your files look fine so in principle it should work. Please
send the output of sudo grep gpib /var/log/messages after booting with the
three adaptors plugged in.
cheers,
-Dave

On Fri, 20 Sep 2019 at 16:46, <[email protected]> wrote:

> Greetings,
>
> I have multiple NI GPIB-USB-HS controllers that I need to use (Ubuntu
> 18.04 LTS, linux-gpib-4.3.0). I've attached my /etc/gpib.conf and
> /etc/udev/rules.d/98-gpib-generic.rules files to show what I currently have
> on my system. I was hoping to have a specific serial number controller
> assigned to a specific /dev/gpib port. Instead, what I am seeing is that
> the first controller that I plug in gets assigned to /dev/gpib0 and the
> second gets assigned to /dev/gpib1. So, either I am doing something wrong,
> or I totally misunderstand the idea of configuring the devices based on
> their serial numbers.
>
> FYI, whenever I've made edits to the config files, I reboot the computer
> to ensure that everything starts fresh. I am hoping that someone can assist
> me with this issue. Is it possible to use the serial numbers to assign a
> controller to a specified /dev/gpib port?
>
> Regards,
>
> Ron
> _______________________________________________
> Linux-gpib-general mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/linux-gpib-general
>

_______________________________________________
Linux-gpib-general mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/linux-gpib-general