Re: Configure NI GPIB-USB-HS based on serial number
Frank Mori Hess <[email protected]>
| Newsgroups | gmane.linux.hardware.gpib.general |
|---|---|
| Message-ID | <CAJz5Opf_95-tk=gDOqKsgYZ8ga50Jjm-uW7fiGnOFzfTsVY1UA@mail.gmail.com> |
On Fri, Sep 20, 2019 at 11:08 AM dave penkler <[email protected]> wrote: > Syntactically your files look fine so in principle it should work. Please send the output of sudo grep gpib /var/log/messages after booting with the three adaptors plugged in. I think the problem is we need to use ACTION="add|change" in 98-gpib-generic.rules, since gpib_config will get run on a change event for the case when the modules aren't already loaded. -- Frank