Re: IRQ problems with PCG-GRS614MP

Sounds like it's probably an ACPI issue as that is the most common
reason for failure of devices assignations around here ;)

Since your on RH9 try the kernel available at

http://www.bardicgrove.org/~tykeal/distributables/ and mirrored @
http://mirror.insue.com/

-Andy-

On Wed, 2003-07-02 at 15:10, Neil Blue wrote:
> Hello,
> 
>  
> 
> I have got my new PCG-GRS614MP, and a new bag of problems J
> 
>  
> 
> I have installed RH9, and I am finding that only one PCMCIA slot
> works, and there is a stack of IRQ errors:
> 
>  
> 
> Dmesg shows:
> 
>  
> 
> Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT
> SHARE_IRQ SERIAL_PCI ISAPNP enabled 
> ttyS0 at 0x03f8 (irq = 4) is a 16550A 
> PCI: No IRQ known for interrupt pin B of device 00:1f.6. 
> Real Time Clock Driver v1.10e 
> floppy0: no floppy controllers found 
> -- 
> hub.c: USB hub found 
> hub.c: 2 ports detected 
> PCI: No IRQ known for interrupt pin C of device 00:1d.2. 
> usb-uhci.c: found UHCI device with no IRQ assigned. check BIOS
> settings! 
> usb-uhci.c: v1.275:USB Universal Host Controller Interface driver 
> -- 
> EXT3-fs: mounted filesystem with ordered data mode. 
> ohci1394: $Rev: 693 $ Ben Collins <[email protected]> 
> PCI: No IRQ known for interrupt pin C of device 02:05.2. 
> ohci1394: Failed to allocate shared interrupt 0 
> SCSI subsystem driver Revision: 1.00
> 
>  
> 
> Has anyone else had this problem, and possibly any ideas as to what is
> wrong. I have tried to make changes in the BIOS, but there is very
> little to change in the BIOS apart form the serial, parallel and ps/2
> port settings.
> 
>  
> 
> cheers
> 
> Neil
> 
>