Re: IRQ problems with PCG-GRS614MP

Neil,

Give a try at installing the kernel that Andy has so kindly put together
for us RH9 folks, it includes ACPI and may solve a lot of your issues
below:

http://returntonature.com/pipermail/linux-sony/2003-July/004810.html

Louis

> Hello,
>
> I have got my new PCG-GRS614MP, and a new bag of problems :-)
>
> I have installed RH9, and I am finding that only one PCMCIA slot works,
> and there is a stack of IRQ errors:
>
> Dmesg shows:
>
> Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT
> SHARE_IRQ SERIAL_PCI ISAPNP enabled
> ttyS0 at 0x03f8 (irq = 4) is a 16550A
> PCI: No IRQ known for interrupt pin B of device 00:1f.6.
> Real Time Clock Driver v1.10e
> floppy0: no floppy controllers found
> --
> hub.c: USB hub found
> hub.c: 2 ports detected
> PCI: No IRQ known for interrupt pin C of device 00:1d.2.
> usb-uhci.c: found UHCI device with no IRQ assigned. check BIOS settings!
>
> usb-uhci.c: v1.275:USB Universal Host Controller Interface driver  --
> EXT3-fs: mounted filesystem with ordered data mode.
> ohci1394: $Rev: 693 $ Ben Collins <[email protected]>
> PCI: No IRQ known for interrupt pin C of device 02:05.2.
> ohci1394: Failed to allocate shared interrupt 0
> SCSI subsystem driver Revision: 1.00
>
> Has anyone else had this problem, and possibly any ideas as to what is
> wrong. I have tried to make changes in the BIOS, but there is very
> little to change in the BIOS apart form the serial, parallel and ps/2
> port settings.
>
> cheers
> Neil