[tlinux-users:07762] Re: Recompiling kernel to enable the Toshiba bios stuff?

Robert Hart <[email protected]>
Newsgroups gmane.linux.hardware.toshiba
Message-ID <[email protected]>
Manuel López-Ibáñez wrote:
> Hi Robert,
>
> Are you really sure about that? It is quite strange that the stuff you 
> need is not compiled as a module because I see no reason to do so, 
> since it just would take a small amount of disk space.
Nope - take a look at the fnfx docs and you'll see you need to compile 
in the Toshiba extensions.

     These functions heavily depend on the system and/or kernel
    configuration.
    You will need at least a kernel (v2.4.x, v2.5.x, v2.6.x) with ACPI and
    Toshiba support (CONFIG_ACPI and CONFIG_ACPI_TOSHIBA).

Further on its says

    To check if ACPI and ACPI Toshiba support are enabled check the
    following proc entries exists:

    /proc/acpi
    /proc/acpi/toshiba

And whilst I have /proc/acpi I don't have  /proc/acpi/toshiba ( I also 
get the predicted errors if I try modprobe toshiba_acpi).

So - I do need to recompile my kernel and I do need a pointer to some 
docs that tell me how to go about this so I don't break everything else!

-- 
Robert Hart                                  [email protected]
+61 (0)438 385 533                           http://www.hart.wattle.id.au
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.