(usagi-users 03433) Re: [ipv6ready-info:02495] Interop Problem using Microsoft Server 2003

Hi Vishal,

netsh interface ipv6 add route ::/0 nexthop=INTERFACE3_Lik_Local_Addr 3 publish=yes

See also,
http://www.microsoft.com/technet/community/columns/cableguy/cg0902.mspx

Anyway you had better ask Microsoft technical support.

best regards,

[email protected] wrote:
>  
>    I am doing  Phase 1 Ready  Interop testing for host implementation in
> my own lab here.
> 
>    Test case : pinging  Offlink host using global address 
>   
>    Test Steps
>      I connected two host (ipv6 )  to two different interface's (NIC) of
> Windows machine , which is  acting as router ( windows server 2003 is
> preinstalled on it)
>      I did follwing configuration on Windows server 2003 router to
> enable IPV6 static routing 
>   
>   1. netsh interface ipv6 set interface 4 FORWARDING= enabled
> ADVERTISE=enabled
>    2 netsh interface ipv6 set interface 3 FORWARDING= enabled
> ADVERTISE=enabled 
>   3 netsh interface ipv6  add route 2001:260:20:1000::/64 4 publish=yes
>    4 netsh interface ipv6 add route 2001:260:20:2000::/64  3 publish=yes
 >
> Problem -
>   I can not do  ping  from one host to another   /vice versa using
> Global Prefix. 
>   Ping6  output says on host   ::  No route to Host.
> 
>  Same configuration works if we change router to FREEBSD/CISCO
> 

-- 
Nobumichi Ozoe
IPv6 Business
Network & Software Development Dept.
Yokogawa Electric Corporation
E-mail: [email protected]
URL: http://www.yokogawa.com/