(usagi-users 03663) Re: Problems with stateless autoconf tests ...

Heiko Gerstung wrote:

> I tried to run the IPv6ready test suite for Phase 1 (from TAHI) on a
> Usage Kernel 2.6.15 (snapshot 2006/03/27 IIRC). Everything went fine
> until it started to go into the Stateless Autoconfiguration section,
> where all tests I tried out failed  (well, I stopped after test 4).
> 
> It says:

(snip)

> I am pretty sure this is a configuration issue. What kind of
> configuration do I have to set up in order to pass these tests?

I think no special configuration is required on these tests.
Could you show me the result of the following command?

$ tcpdump -e -n -vvv -r ./stateless-addrconf/1.html.Link0.dump

Thank you,
-- 
Mitsuru Chinen <[email protected]>