(usagi-users 03664) Re: Problems with stateless autoconf tests ...

>Heiko,
>Issue  "sysctl -a | grep accept_ra"
>If "net.ipv6.conf.eth0.accept_ra" (assuming eth0) is set to 0, then use
>the "sysctl" program to add the following:
>"net.ipv6.conf.eth0.accept_ra = 1" - Stateless autoconfiguration 
>
>Issue  "sysctl -a | grep dad_transmits"
>If "net.ipv6.conf.eth0.dad_transmits" (assuming eth0) is set to 0, then
>use the "sysctl" program to add the following:
>"net.ipv6.conf.eth0.dad_transmits = 3" - Duplicate Address Detection
>probes to send.
>
>Phil Bellino 


Hi, Phil:

Thank you for your help. In fact, the two settings (net.ipv6.conf.eth0.accept_ra and .dad_transmits) are both enabled (=1), but no DAD_NS is detected. Any other possibilies?

Kind regards,
Heiko