Re: chan_lcr bad quality

On 21/10/13 07:03, Tamer Higazi wrote:
> How do you know that this issue is not an asterisk case ?!

I don't.

> Do you have a "white noise" in the line or is it just loud ?!

The transmission is barely intelligible, I suspect massive package loss.

> The volume can be handled through asterisk with the chan_lcr config
> variables for sure.

That was my specific question, HOW can I set chan_lcr config variables
in asterisk?

> Why don't you figure out to get some debug informations for the mISDN
> people and post it on pastebin for the developers to have a look on it
> to figure out if it's a chan_lcr coding issue or just asterisk tweaks to
> accomplish?!

Same. My question was HOW can I get meaningful debug info? All I got now is:

[call=1002 ast=lcr/3 line=1696] Message 15 from LCR unhandled.
(once, in asterisk cli)

ERROR (in message_epoint() line 2954) Pdss1(ext-0-out) isdn port with
(caller id *******) received a wrong message: 3
(three times in LCR cli)

mISDN_send: error -12
(too numerous to count, in dmesg)


> I don't believe that the developers will make for YOU (as they did not
> for me) a solution.
I never asked for that.

Thomas