Re: Problem with driverloader

Hi,

you are right, the master mode is not supported by DriverLoader.

Did you tried to connect to an access point (managed mode) to see if you 
have the same stability issue or not?

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



Dirk Handzic wrote:
> I am using driverloader on a FC6 system with a Netgear WG311v2 adapter. 
> I am using the board in ad-hoc mode (master does not seem to be 
> supported) to work as a router for other computers to access the 
> internet. The board is recognized and working for a while but ceases to 
> work. After running dldrconfig again the board will work for some time 
> again (sometimes only minutes). I am using the latest W2K/XP routines 
> available for this board. I have used it previously on an older system 
> with RH9 and an older version of driverloader without a problem.
> 
> _______________________________________________
> driverloader mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/driverloader