Re: Problem with driverloader

The board is sitting on our server which has the internet connection and 
serves as firewall, router and wlan access point. That is why I am using 
it in ad-hoc mode. It would be preferrable to use it in master mode to 
make it an access point but neither the board nor driverloader does 
support this.

-- 
Best regards

Dirk Handzic





Linuxant support (Jonathan) skrev:
> Hi,
>
> you are right, the master mode is not supported by DriverLoader.
>
> Did you tried to connect to an access point (managed mode) to see if 
> you have the same stability issue or not?
>
> Regards,
>
>
> Jonathan
> Technical specialist / Linuxant
> www.linuxant.com
> [email protected]
>
>
>
> Dirk Handzic wrote:
>> I am using driverloader on a FC6 system with a Netgear WG311v2 
>> adapter. I am using the board in ad-hoc mode (master does not seem to 
>> be supported) to work as a router for other computers to access the 
>> internet. The board is recognized and working for a while but ceases 
>> to work. After running dldrconfig again the board will work for some 
>> time again (sometimes only minutes). I am using the latest W2K/XP 
>> routines available for this board. I have used it previously on an 
>> older system with RH9 and an older version of driverloader without a 
>> problem.
>>
>> _______________________________________________
>> driverloader mailing list
>> [email protected]
>> https://www.linuxant.com/mailman/listinfo/driverloader
>