Re: dnsmasq dhcp failure

hi.

there's trouble with dns on dnsmasq under heavy load too, at least with 
dnsmasq 2.80 on x86_64. sometimes it crashes, sometimes it just hangs, 
especially when there's troubles with dns resolving (NSes aren't 
responding).

I'll think on monit scripts for it's check.

26.11.2022 00:02, Erich Titl пишет:
> Hi Folks
>
> News on the dhcp front
>
> As reported before my dnsmasq installation would not hand out leases 
> to my winblows 10 over Wifi, well through a bridged configuration and 
> an external AP. Funny enough Android could get an address.
>
> It may be noted that the system is _very_ old, a WRAP with really 
> little memory.
>
> Also I found that for a certain time dhcp would run fine after system 
> boot. After some time it just degenerated.
>
> Now I disabled dhcp in dnsmasq and installed the good old 
> isc-dhcpserver aka dhcpd, configured it accordingly and bingo, my 
> win10 system gets its address reliably and my Android system gets it 
> _fast_.
>
> I have seen this behaviour only on old systems with _very_ little 
> memory, I tend to still use them.
>
> For the moment this configuration appears to be stable, but time will 
> tell.
>
> cheers
>
> ET
>
>
> ------------------------------------------------------------------------
> leaf-user mailing list: [email protected]
> https://lists.sourceforge.net/lists/listinfo/leaf-user
> Support Request -- http://leaf-project.org/




------------------------------------------------------------------------
leaf-user mailing list: [email protected]
https://lists.sourceforge.net/lists/listinfo/leaf-user
Support Request -- http://leaf-project.org/